Wheat combine harvester storage method

First, open the lid, a wheat combine harvester, thoroughly clean the machine on the inside and outside dust,wheat straw, wheat, weed.

Two, pulled into the garage, release the oil, cooling water. And dehydration on the lubricating oil added (heated to110－150 ℃, until the bubble disappeared) treatment. Then turn the crankshaft several times, to fill the entirelubrication system. Use plastic cloth put the air filter, exhaust pipe, radiator cap, fuel tank cap bandage.

Three, the wheat combine harvester header on the skids prepared, on axle jack, a good padding, so the tire off the ground. In order to reduce the pressure on the tire inner pressure, the tire pressure to 0.05 mpa.

Four, remove all belt (belt), after identification technology, still can use, to clean, coated with talcum powder,attached the label, stored in a cool dry place. If you want to go to the wall hanging, should as far as possible not to let the belt rolling.

Five, remove the drive chain and walkers on the wooden bush, washed sludge, dig up the sticky oil, soaked in oil in a day or on the absolute oil immersed for 20 - 30 minutes, remove and, to be stuck on the net oil droplets, andkraft paper or plastic sheeting were wrapped in well, put in ventilated and dry indoor preservation.

Six, according to the lubrication chart, add butter with oil to the lubrication, the various parts of the lubrication of wheat combine harvester.

Seven, remove the battery, the sole custody of the custody period, a monthly charge. To clean the electrodecharge, coated with vaseline.